Pilot Light Installation in Cibolo, TX

A standing pilot stays lit continuously and powers the system through its own thermopile, so it works during a power outage but burns a small amount of gas around the clock. An electronic-ignition (intermittent) pilot lights only on demand, which saves that standby gas but usually needs power to ignite. The right choice depends on whether outage-proof operation or standby efficiency matters more to you. We walk through that trade-off for your specific setup rather than defaulting to one, since both are valid and code-compliant when installed correctly.

It's integral to a proper install, not an add-on. A correctly installed pilot assembly includes the flame-failure safety — the thermocouple or thermopile that holds the gas valve open only while the pilot flame is actually present. If the pilot goes out, that interlock closes the main valve and stops the gas. That safety function is the entire reason a pilot system is preferable to a bare manual valve, so we set it up and verify the interlock drops the gas when the pilot is interrupted before the job is considered done.

Usually, but it has to be matched to your burner and gas type — pilot assemblies are sized to a specific input and configuration, and the components have to suit the appliance. We confirm the burner's rating and your fuel before sourcing the assembly so the pilot flame is correctly proportioned to light the burner reliably and hold the safety circuit. Fitting a mismatched pilot can cause nuisance dropouts or an unreliable light-off, so the compatibility check comes before the install, not after.

We verify the pilot flame is properly shaped and seated on the sensor, measure that the thermocouple or thermopile produces the voltage the valve needs, confirm the main burner lights cleanly off the pilot, and then deliberately interrupt the pilot to prove the safety interlock closes the gas. We also leak-test the connections we made per the fuel gas code. A pilot that lights is the starting point; proving the flame-failure safety actually shuts the gas off is the part that makes it safe to leave in service.

Yes — our crews cover Cibolo's 2 ZIP codes across Guadalupe County, including Falcon Ridge, Bentwood Ranch, Steele Creek, plus the surrounding communities.

We offer same-week scheduling across Cibolo, booked by a real person in under two minutes, 7 AM to midnight every day.

Cibolo's rapid buildout through Bentwood Ranch and Falcon Ridge has filled the city with newer single-family homes and the prefabricated fireplace systems that come with them, where listed clearances and intact liners are the safety baseline. Our CSIA-certified inspectors run NFPA 211 Level 1 verification on these factory units, catching cracked refractory panels and warped dampers that never show from the hearth. In Steele Creek and The Reserve, we apply Level 2 video where larger custom builds carry full masonry chimneys that conceal flue and smoke-chamber defects. Pilot Light Installation is part of keeping that local housing stock safe, efficient, and up to code.