Gas Fireplace Repair in Cibolo, TX

That is the textbook signature of a weak or failed thermocouple. The thermocouple sits in the pilot flame and generates a small millivolt signal that holds the pilot safety valve open; when it can't produce enough voltage, the valve closes and shuts the gas the instant you stop holding the knob. It's a low-cost part, but the diagnosis matters — a dirty pilot orifice or a misaligned flame can mimic the same symptom, so we verify the millivolt output before replacing anything.

You should respect it. Any fuel-burning appliance produces CO, and the safety margin depends on complete combustion and proper venting. Yellow, lazy, sooting flames, a sooty glass front, or a unit that has never been serviced are the warning signs of incomplete combustion. We check flame character, verify the venting draws correctly, and confirm a working CO alarm is present — the standard calls for one on every level with sleeping areas. If we find spillage, we red-tag the appliance rather than leave it in service.

For a simple gust-blown-out pilot, the lighting sequence is printed on the unit and you can do it yourself. We won't bill you to walk through that. A service call is warranted when the pilot won't stay lit, won't light at all, or you smell gas — those indicate a component fault (thermocouple, thermopile, valve, or igniter) that needs measurement and a leak check, not just a relight. If you smell gas, shut the supply valve and ventilate before anything else.

Every gas repair ends with verification, not just a working flame. We leak-test the connections we touched per the fuel gas code, confirm the pilot safety circuit drops the gas when the flame is interrupted, check that the flame pattern is clean and seated on the burner, and verify the venting carries combustion products out rather than back into the room. A fireplace that lights is not the same as a fireplace that's safe — the test sequence is what separates the two.

Both are flame-driven sensors, but they do different jobs. The thermocouple is the safety device — it holds the pilot valve open and outputs a few dozen millivolts. The thermopile is a stack of thermocouples that generates several hundred millivolts, enough to actually power the main gas valve and your wall switch or remote on a standing-pilot system. A fireplace whose pilot stays lit but won't respond to the switch usually has a weak thermopile, not a thermocouple — telling them apart is a meter reading, not a guess.

Yes — our crews cover Cibolo's 2 ZIP codes across Guadalupe County, including Falcon Ridge, Bentwood Ranch, Steele Creek, plus the surrounding communities.

We offer same-week scheduling across Cibolo, booked by a real person in under two minutes, 7 AM to midnight every day.

Cibolo's rapid buildout through Bentwood Ranch and Falcon Ridge has filled the city with newer single-family homes and the prefabricated fireplace systems that come with them, where listed clearances and intact liners are the safety baseline. Our CSIA-certified inspectors run NFPA 211 Level 1 verification on these factory units, catching cracked refractory panels and warped dampers that never show from the hearth. In Steele Creek and The Reserve, we apply Level 2 video where larger custom builds carry full masonry chimneys that conceal flue and smoke-chamber defects. Gas Fireplace Repair is part of keeping that local housing stock safe, efficient, and up to code.