Gas Valve Replacement in Alamo Heights, TX

A gas valve is a sealed, safety-critical assembly — the seats, solenoids, and pilot section are matched and factory-set, and they aren't field-rebuildable in a way that can be certified gas-tight. When the internals fail, the defensible repair is to replace the unit with an OEM-compatible valve and prove the new one holds, rather than open a safety device and hope. That's the same logic the codes and manufacturers use; a valve isn't a component you take apart and reassemble in a firebox.

It has to be matched to your ignition type, which is exactly what we confirm before ordering. A standing-pilot system needs a millivolt valve that the thermopile can power directly; an electronic-ignition system needs the corresponding control valve and module. Installing the wrong type breaks the control scheme even if the gas connects fine. We identify your system first, then source a valve compatible with your existing controls so the switch, remote, or thermostat keeps working as before.

If the valve is leaking gas or won't shut off reliably, yes — shut the supply and keep it off until it's replaced, because both of those are uncontrolled-gas conditions. A valve that simply won't open is an inconvenience rather than a hazard, but a valve that won't fully close or that weeps gas is the kind of fault the safety system exists to prevent. When in doubt, the conservative move is to isolate the gas, and that's what we'd advise on the phone before we ever arrive.

After fitting the OEM-compatible valve, we leak-test the new connections per the fuel gas code, confirm the valve shuts off completely in the closed position, verify the flame-failure interlock drops the gas when the pilot is interrupted, and check the flame pattern and venting once the appliance is running. We document that the connection is gas-tight. Replacing the valve is only half the job — proving the new assembly is leak-free and the safety circuit functions is what actually returns the fireplace to service.

Yes — our crews cover Alamo Heights's 1 ZIP code across Bexar County, including Olmos Park line, Terrell Hills, Lower Alamo Heights, plus the surrounding communities.

We offer same-week scheduling across Alamo Heights, booked by a real person in under two minutes, 7 AM to midnight every day.

Alamo Heights is defined by its early-20th-century masonry homes -- some of the oldest chimney stock our certified inspectors handle anywhere in the area -- where original clay-tile liners and unlined flues are common and rarely meet current code. Near Terrell Hills and the Olmos Park line, the work that dominates is Level 2 video inspection of these historic systems, documenting cracked tile, deteriorated mortar, and creosote in flues that have served wood fires for generations. We assess every finding against NFPA 211 before any unit is cleared. Gas Valve Replacement is part of keeping that local housing stock safe, efficient, and up to code.