Gas Valve Repair in San Antonio, TX

First, before diagnosing anything: shut off the gas supply valve, ventilate the room, avoid switches and flames, and leave if the odor is strong. A gas smell can come from the valve body, the connections, or the pilot assembly — it isn't automatically the valve. When we arrive we locate the source with a leak test rather than assuming, because the fix for a leaking valve seat is different from the fix for a loose union. Any gas odor is a stop-and-verify situation, not a wait-and-see one.

Some valve faults are serviceable — a sticky pilot adjustment or a fouled passage can sometimes be cleaned and restored. But a valve leaking at the body or with a failed internal seat is generally replaced, because you can't reliably reseal an internal failure in the field and the valve is a safety-critical part. We diagnose which it is by testing, and we're conservative: if there's any doubt about a valve holding gas reliably, replacement is the defensible call, not a patch.

We pressure- and leak-test the valve and the connections we worked on per the fuel gas code, confirm the valve fully shuts off flow when closed, and verify the flame-failure safety still drops the gas if the pilot is interrupted. Only after those checks pass does the appliance go back in service. A valve that operates is not the same as a valve that's proven gas-tight — the test sequence is the actual deliverable on a gas repair.

Not necessarily, and that distinction saves you money. On a millivolt system, the wall switch and remote operate the main valve using power from the thermopile. If the pilot stays lit but the switch does nothing, the most common cause is a weak thermopile that can't produce enough voltage to open the valve, or a wiring or receiver fault — not the valve itself. We measure the thermopile output and the switch circuit before condemning the valve, because replacing a good valve won't fix a sensor problem.

Yes — our crews cover San Antonio's 110 ZIP codes across Bexar County, including Alamo Heights line, Stone Oak, Monte Vista, plus the surrounding communities.

We offer same-week scheduling across San Antonio, booked by a real person in under two minutes, 7 AM to midnight every day.

San Antonio's deep housing range — from the 1920s masonry of Monte Vista and King William to the newer construction in Stone Oak — means our CSIA-certified inspectors apply the full NFPA 211 framework across vastly different chimney ages. Historic districts along the Alamo Heights line frequently reveal unlined clay-tile flues and deteriorated mortar that only Level 2 video can fully document, while Stone Oak's prefab systems need clearance and liner verification. Across the city, we focus inspection on the smoke chamber and flue transitions where creosote concentrates and structural cracking begins. Gas Valve Repair is part of keeping that local housing stock safe, efficient, and up to code.