Spark Arrestor Installation in San Antonio, TX

NFPA 211 is specific: the arrestor's openings must not allow a sphere larger than 1/2 inch to pass, and must not block a sphere smaller than 3/8 inch. That window keeps the screen tight enough to catch embers while still letting the chimney breathe. A screen with oversized holes lets sparks escape onto the roof; one that's too fine clogs with soot and chokes draft. We install arrestors built to that 3/8-to-1/2-inch standard rather than generic hardware cloth.

Only if it's the wrong screen or it's left dirty. NFPA 211 requires the arrestor to have a net free area at least three times the chimney outlet, specifically so it doesn't strangle the flow of gases. A properly sized arrestor maintains draft; the real risk is neglect — soot and creosote accumulating on the mesh can blind it over a season. We size to that 3x rule and recommend the screen be checked at your annual inspection so it stays open.

For chimneys serving solid-fuel appliances, a spark arrestor is required under NFPA 211, and many local fire codes mandate them outright — particularly in wildfire-prone and wildland-urban-interface areas where an escaping ember can ignite a roof or brush. Beyond code, it's simply sound fire practice. We install corrosion- and heat-resistant arrestors that meet the material and opening requirements, because a rusted or undersized screen defeats the purpose it was put there for.

Yes, and it usually should be. Many quality caps integrate a code-compliant arrestor screen, so a single component sheds rain off the flue, blocks animals, and arrests sparks at once. The key is that the integrated screen still meets the 3/8-to-1/2-inch opening rule and the 3x net-free-area requirement — some decorative caps don't. We verify the arrestor specification on any combined cap so you get genuine ember protection, not just a lid.

Yes — our crews cover San Antonio's 110 ZIP codes across Bexar County, including Alamo Heights line, Stone Oak, Monte Vista, plus the surrounding communities.

We offer same-week scheduling across San Antonio, booked by a real person in under two minutes, 7 AM to midnight every day.

San Antonio's deep housing range — from the 1920s masonry of Monte Vista and King William to the newer construction in Stone Oak — means our CSIA-certified inspectors apply the full NFPA 211 framework across vastly different chimney ages. Historic districts along the Alamo Heights line frequently reveal unlined clay-tile flues and deteriorated mortar that only Level 2 video can fully document, while Stone Oak's prefab systems need clearance and liner verification. Across the city, we focus inspection on the smoke chamber and flue transitions where creosote concentrates and structural cracking begins. Spark Arrestor Installation is part of keeping that local housing stock safe, efficient, and up to code.